Automatic abrasive removal system for water jet cutting

Some waste abrasive will be produced during the water cutting process. If the waste abrasive cannot be removed in time and enters the water jet cutting system, the cutting quality will be directly affected. However, the traditional removal method is not perfect after all, and there are many disadvantages. Therefore, a abrasive removal system is designed on this basis.

This is a equipment specially developed for water jet cutting to remove waste abrasive. It is also a relatively reasonable and simple desanding system in water jet cutting at present. No matter its characteristics or use effect, the mobile desanding system has various advantages that traditional removal can not compare.

Practice has proved that the mobile automatic desanding device in the water jet cutting system not only has a high desanding rate, which reaches more than 90%, but also has a very high working efficiency. It only takes 15-20 minutes to remove the entire tank. The mobile automatic desanding system used in water jet cutting is integrated with the water abrasive separation system. The base is made of 20mm thick steel plate, which makes the equipment more durable.

Moreover, the manual hydraulic system is adopted for opening and closing the cabin door, which makes the opening and closing of the cabin door simple, safe and convenient. At the same time, it is also equipped with a desanding pump, which is driven by electricity to generate a continuous high-pressure water flow, which is more energy-saving. The whole desanding process will not consume water in the water jet cutting process, nor cause waste of water resources.

With such a supporting system, there is no need to worry about various faults caused by waste abrasive during water jet cutting. At the same time, it also needs to spend time and energy on desanding, and the work efficiency has been significantly improved.